Converting from SW 2.0.2 to SW 2.1
A31003-K16-X001-3-7620, 07/99
Hicom 100 E Version 2.1, Service manual
6-21
Initial operation
6.12 Converting from SW 2.0.2 to SW 2.1
Procedure
:
●
Use Assistant_L to make a copy of the customer configuration on the SW 2.0.2 system
(save this to disk as e.g. "data202.kds")
●
From extension 11 enter the password *95 13290396 and power off the system. Follow pro-
cedure "Upgrading a sytem", see Section 6.11. Load the new 2.1 software.
●
The system restarts automatically.
●
Enter the password *95 followed the Nationalisation code (Section 6.3). Perform a power
reset.
●
Enter the password *95 62659321. Perform a second power reset.
●
Prepare an empty datatbase by taking a download (PABX to PC) of the upgraded and de-
fault system using Assistant_L.
●
Save this database to disk (e.g.new21.kds).
●
Open the customer database "data202.kds".
●
Transpose this 2.0.2 customer database (data202.kds) on to the new 2.1 default datbase
"new21.kds", (the destination file). This is done by selecting "File and Convert" within
Assistant_L.
●
A new file is automatically created, "konvert.kds". This contains the customer programming
on the SW 2.1 matrix and may be uploaded to the system.
To Next Page
Loading...
Need help?
General