Siemens Hicom 112

Networking (Hicom 112/118 only
)
A31003-K16-X001-3-7620, 07/99
Hicom 100 E Version 2.1, Service manual
6-17
Initial operation
Error messages must be acknowledged before you proceed with programming.
Assign codes
Collision with 221
substitute code *
Collision with the substitute code for *
Collision with 222
substitute code #
Collision with substitute code for #
Collision with 223
line X
Collision with a line code
Collision with
internal console code
Collision with the console code (inter-
cept console)
Collision with 224
route X, pos. X
Collision with specified route code
when entering route codes
Collision with 1616
digit repetition
Digit repetition was deactivated when
attempt was made to assign additio-
nal route codes
Setting Message Remarks
Table 6-2 Error messages for network settings