System programming in interactive mod
A31003-K16-X001-3-7620, 07/99
Hicom 100 E Version 2.1, Service manual
7-7
Administration and maintenance
7.5 System programming in interactive mode
Hicom 100E is programmed at the optiset connected to the U
P0/E
user PEN 01 or 02 (internal
number
11
or
12
) after starting access-protected system administration. See Section 7.6.1
It is advisable to use an optiset memory telephone. Due to the improved user interface for ter-
minals with a two-line display, it is also possible to use an optiset base, optiset E standard or
an optiset E advanced.
The offered menus can be addressed via a number of keys. Branching is implemented as you
move to higher-level or lower-level menus.
You must always acknowledge error messages! If an error message is issued because a code
has already been assigned, the expert code appears at the beginning of the second line of the
display. This code can be used to branch to the appropriate section of the menu.
The functions assigned to function keys F1 to F8 appear in the menu.
General key functions:
+
scroll down
-
scroll up
F2
continue/go to next code
F3
delete
F7
previous/quit
F8
return to main menu
Simply follow the user prompts; the system will always inform you of available and unavailable
(error messages) options and will recommend corrective measures using expert mode (branch
address to collision entry found).
To Next Page
Loading...
Need help?
General