Standard extension number plan
A31003-K16-X001-3-7620, 07/99
Hicom 100 E Version 2.1, Service manual
3-9
Overview of modules
3.3.2 Extension number plans of the add-on modules
The extension number plans of the add-on modules have been changed relative to that of
SW 2.0.1. The new assignment of the extension numbers and line numbers ensures consistent
numbering at all times whenever the system is expanded. Attention must be paid to the new
equipping sequence for extension and trunk modules.
Figure 3-2 Equipping sequence for extension and trunk modules
The structure of the extension number plans is described in
more detail in Chapter 5,
Installation of the Service Manual (see Section 5.5).
MB
Slot 1
Slot 2
Slot 3
Slot 4
Trunk module
Extension module
View from the PSU side
To Next Page
Loading...
Need help?
General