Station attributes
Programming guide
A31003-K16-X001-3-7620
,
07/99
10-22
Hicom 100 E Version 2.1, Service manual
10.5.1.8 Caller list (as of SW version 2.0.2)
Each extension is authorised (default) to use an individual caller list.
This class of service can be blocked.
Example
: block caller list for ext. 12.
10.5.1.9 Call trace (as of SW version 2.0.2)
If the "call trace" feature (tracing nuisance/malicious callers) has been released by Telecom,
this class of service can be assigned to all extensions.
Example
: ext. 13 is assigned call trace class of service
Input sequence Meaning Display
A1 3
2 0 Caller list for ext. 11
(select ext. 11–74 with "+" and "–" or
directly with "#")
Ext. 11: yes
B+
Caller list for ext. 12 Ext. 12: yes
C*
Change input Ext. 12:
D0
Block call list Ext. 12: no
E<OK>
Confirm input Ext. 12: no
F
<F8> Return to Start menu System administration
A caller list can be released again by entering "1" under point D.
Input sequence Meaning Display
A1 3
2 1 Call trace class of service for ext. 11
(select ext. 11–74 with "+" and "–" or
directly with "#")
Ext. 11: not enabled
B+
Call trace class of service for ext. 12 Ext. 12: not enabled
C
+ Call trace class of service for ext. 13 Ext. 13: not enabled
D*
Change input Ext. 13:
E1
Enable call trace Ext. 13: enabled
F<OK>
Confirm input Ext. 13: enabled
G
<F8> Return to Start menu System administration
Call trace class-of-service can be deactivated by entering "0" under point E.
To Next Page
Loading...
Need help?
General