Program instructions
7.13 Program control
S7-200 SMART
314 System Manual, 09/2015, A5E03822230-AC
You should use compare logic to save the ECODE value in another memory location. Your
program can then test the saved error code value and begin a programmatic reaction.
Note
The error codes for the ECODE output are listed in the PLC non
-fatal error codes table (see
reference below). The error code values are in hexadecimal (16#xxxx).
PLC non-fatal error codes (Page 657)
PLC non-fatal error SM flags (Page 660)
To Next Page
Loading...
