Communication
8.4 Ethernet
S7-200 SMART
366 System Manual, 09/2015, A5E03822230-AC
Configuring the IP information in the System Block dialog (static IP information)
IP information configuration or changes done in the system block are part of the project and
do not become active until you download your project to the CPU.
To access this dialog, perform one of the following:
In the Navigation bar, click the "System Block" button.
In the Project tree, select the "System Block" node, then
press Enter; or double-click the "System Block" node.
To enter or change IP information, perform the following:
● If not already checked, click the "IP address data is fixed to the values below and cannot
be changed by other means" checkbox. The Ethernet port IP information fields are
enabled.
● Enter or change the following IP information:
– IP address
– Subnet mask
– Default gateway
– Station name
To Next Page
Loading...
