. . . . .
CONVEYOR ENHANCEMENTS
Checkmate™ Hold Down Conveyor Installation
2-9317-600-00-0 Aquastorm™ Series Options Guide 6-95
Diagram Figure 6–10 shows the CheckMate™ wire belt installation drawing:
Figure 6–10
Tools and Materials Use the following tools to install CheckMate™ wire belt:
• Roll of conveyor wire belt
• Wire belt master link set
• Needle nose pliers
• Small flat head screwdriver
Feed the CheckMate™ Wire Belt
Lay the wire belt, smooth side down, on top of
the conveyor belt. Feed it toward the exit end
of the system, then around to the top of the
CheckMate™ conveyor, toward the entrance end.
Connect the CheckMate™ Wire Belt Ends
Ensure at least 15.24 cm (6 in.) of conveyor
belt is left as slack at each end of the CheckMate™
conveyor prior to installing the master link.
To Next Page
Loading...