YASKAWA Sigma-7 SGD7S Series - Page 149

Tool Function Reference
Digital Operator You cannot write Linear Servomotor parameters from the
Digital Operator.
SigmaWin+ Setup - Motor Parameter
Scale Write
Ä ‘Operating Procedure’
page 149
Use the following procedure to write the motor parameters to the linear encoder.
1. Prepare the motor parameter file to write to the linear encoder.
2.
Click the Servo Drive Button in the workspace of the Main Window of the Sig-
maWin+.
3. Select Motor Parameter Scale Write in the Menu Dialog Box.
ð
The Motor Parameter Scale Write Dialog Box will be displayed.
4. Click the OK Button.
Fig. 100: Motor parameter scale write - Warning
ð
Click the Cancel Button to cancel writing the motor parameters to the linear
encoder. The Main Window will return.
If the write is completed normally, the Motor Parameter Scale Write - File Select
Dialog Box will be displayed.
5. Click the Ref. Button.
Fig. 101: Motor parameter scale write - File select
Operating Procedure
Sigma-7 Series SERVOPACKs
Basic Functions That Require Setting before Operation
Writing Linear Servomotor Parameters
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 149