WARNING!
– Use a power supply with specifications (number of phases,
voltage, frequency, and AC/DC type) that are appropriate for the
product.
There is a risk of burning, electric shock, or fire.
– Connect the ground terminals on the SERVOPACK and Servo-
motor to ground poles according to local electrical codes (100 Ω
or less for a SERVOPACK with a 100-VAC or 200-VAC power
supply, and 10 Ω or less for a SERVOPACK with a 400-VAC
power supply).
There is a risk of electric shock or fire.
– Do not attempt to disassemble, repair, or modify the product.
There is a risk of fire or failure. The warranty is void for the product if
you disassemble, repair, or modify it.
CAUTION!
– The SERVOPACK heat sinks, Regenerative Resistors, Servomo-
tors, and other components can be very hot while power is ON
or soon after the power is turned OFF. Implement safety meas-
ures, such as installing covers, so that hands and parts such as
cables do not come into contact with hot components.
There is a risk of burn injury.
– For a 24-VDC power supply, use a power supply device with
double insulation or reinforced insulation.
There is a risk of electric shock.
– Do not damage, pull on, apply excessive force to, place heavy
objects on, or pinch cables.
There is a risk of failure, damage, or electric shock.
– The person who designs the system that uses the hard wire
base block safety function must have a complete knowledge of
the related safety standards and a complete understanding of
the instructions in this document.
There is a risk of injury, product damage, or machine damage.
– Do not use the product in an environment that is subject to
water, corrosive gases, or flammable gases, or near flammable
materials.
There is a risk of electric shock or fire.
Sigma-7 Series SERVOPACKs
General
Safety Precautions > Safety Precautions That Must Always Be Observed
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 26
To Next Page
Loading...
