NOTICE!
– Do not attempt to use a SERVOPACK or Servomotor that is dam-
aged or that has missing parts.
– Install external emergency stop circuits that shut OFF the power
supply and stops operation immediately when an error occurs.
– In locations with poor power supply conditions, install the nec-
essary protective devices (such as AC Reactors) to ensure that
the input power is supplied within the specified voltage range.
There is a risk of damage to the SERVOPACK.
– Use a Noise Filter to minimize the effects of electromagnetic
interference.
Electronic devices used near the SERVOPACK may be affected by
electromagnetic interference.
– Always use a Servomotor and SERVOPACK in one of the speci-
fied combinations.
– Do not touch a SERVOPACK or Servomotor with wet hands.
There is a risk of product failure.
CAUTION!
Do not place an excessive load on the product during storage.
(Follow all instructions on the packages.)
There is a risk of injury or damage.
NOTICE!
Do not install or store the product in any of the following locations.
– Locations that are subject to direct sunlight
– Locations that are subject to ambient temperatures that exceed
product specifications
– Locations that are subject to relative humidities that exceed product
specifications
– Locations that are subject to condensation as the result of extreme
changes in temperature
– Locations that are subject to corrosive or flammable gases
– Locations that are near flammable materials
– Locations that are subject to dust, salts, or iron powder
– Locations that are subject to water, oil, or chemicals
– Locations that are subject to vibration or shock that exceeds product
specifications
– Locations that are subject to radiation
If you store or install the product in any of the above locations, the
product may fail or be damaged.
Storage Precautions
Sigma-7 Series SERVOPACKs
General
Safety Precautions > Safety Precautions That Must Always Be Observed
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 27
To Next Page
Loading...
