CAUTION!
– Transport the product in a way that is suitable to the mass of the
product.
– Do not use the eyebolts on a SERVOPACK or Servomotor to
move the machine.
There is a risk of damage or injury.
– When you handle a SERVOPACK or Servomotor, be careful of
sharp parts, such as the corners.
There is a risk of injury.
– Do not place an excessive load on the product during transpor-
tation. (Follow all instructions on the packages.)
There is a risk of injury or damage.
NOTICE!
– Do not hold onto the front cover or connectors when you move a
SERVOPACK.
There is a risk of the SERVOPACK falling.
– A SERVOPACK or Servomotor is a precision device. Do not drop
it or subject it to strong shock.
There is a risk of failure or damage.
– Do not subject connectors to shock.
There is a risk of faulty connections or damage.
– If disinfectants or insecticides must be used to treat packing
materials such as wooden frames, plywood, or pallets, the
packing materials must be treated before the product is pack-
aged, and methods other than fumigation must be used.
Example: Heat treatment, where materials are kiln-dried to a core
temperature of 56°C for 30 minutes or more.
If the electronic products, which include stand-alone products and
products installed in machines, are packed with fumigated wooden
materials, the electrical components may be greatly damaged by the
gases or fumes resulting from the fumigation process. In particular,
disinfectants containing halogen, which includes chlorine, fluorine,
bromine, or iodine can contribute to the erosion of the capacitors.
– Do not overtighten the eyebolts on a SERVOPACK or Servo-
motor.
If you use a tool to overtighten the eyebolts, the tapped holes may be
damaged.
Transportation Precau-
tions
Sigma-7 Series SERVOPACKs
General
Safety Precautions > Safety Precautions That Must Always Be Observed
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 28
To Next Page
Loading...
