CAUTION!
– Install the Servomotor or SERVOPACK in a way that will support
the mass given in technical documents.
– Install SERVOPACKs, Servomotors, and Regenerative Resistors
on nonflammable materials.
Installation directly onto or near flammable materials may result in
fire.
– Provide the specified clearances between the SERVOPACK and
the control panel as well as with other devices.
There is a risk of fire or failure.
– Install the SERVOPACK in the specified orientation.
There is a risk of fire or failure.
– Do not step on or place a heavy object on the product.
There is a risk of failure, damage, or injury.
– Do not allow any foreign matter to enter the SERVOPACK or Ser-
vomotor.
There is a risk of failure or fire.
NOTICE!
– Do not install or store the product in any of the following loca-
tions.
– Locations that are subject to direct sunlight
– Locations that are subject to ambient temperatures that exceed
product specifications
– Locations that are subject to relative humidities that exceed
product specifications
– Locations that are subject to condensation as the result of
extreme changes in temperature
– Locations that are subject to corrosive or flammable gases
– Locations that are near flammable materials
– Locations that are subject to dust, salts, or iron powder
– Locations that are subject to water, oil, or chemicals
– Locations that are subject to vibration or shock that exceeds
product specifications
– Locations that are subject to radiation
If you store or install the product in any of the above locations, the
product may fail or be damaged.
– Use the product in an environment that is appropriate for the
product specifications.
If you use the product in an environment that exceeds product specifi-
cations, the product may fail or be damaged.
– A SERVOPACK or Servomotor is a precision device. Do not drop
it or subject it to strong shock.
There is a risk of failure or damage.
– Always install a SERVOPACK in a control panel.
– Do not allow any foreign matter to enter a SERVOPACK or a Ser-
vomotor with a Cooling Fan and do not cover the outlet from the
Servomotor’s cooling fan.
There is a risk of failure.
Installation Precautions
Sigma-7 Series SERVOPACKs
General
Safety Precautions > Safety Precautions That Must Always Be Observed
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 29
To Next Page
Loading...
