ð
When the following dialog box is displayed, click the OK Button
and then confirm that the correct moment of inertia ratio is set in
Pn103 (Moment of Inertia Ratio).
Fig. 250: Tuning - Warning - The Moment of Inertia Ratio has never been changed from
the default setting
Sigma-7 Series SERVOPACKs
Tuning
Autotuning with a Host Reference > Operating Procedure
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 343
To Next Page
Loading...
