YASKAWA Sigma-7 SGD7S Series - Page 668

Param-
eter No.
Size Name Setting
Range
Setting
Unit
Default
Setting
Appli-
cable
Motors
When
Enabled
Classifi-
cation
Refer-
ence
Pn00A 2 Application
Function
Selections A
0000h to
1044h
– 0001h All After
restart
Setup -
n.X
Motor Stopping Method for Group 2 Alarms Reference
0 Apply the dynamic brake or coast the motor to a
stop (use the stopping method set in Pn001 =
n.X).
Ä Chap. 6.13.2
‘Stopping
Method for
Servo OFF’
page 174
1 Decelerate the motor to a stop using the torque set
in Pn406 as the maximum torque. Use the setting
of Pn001 = n.X for the status after stopping.
2 Decelerate the motor to a stop using the torque set
in Pn406 as the maximum torque and then let the
motor coast.
3 Decelerate the motor to a stop using the decelera-
tion time set in Pn30A. Use the setting of Pn001 =
n.X for the status after stopping.
4 Decelerate the motor to a stop using the decelera-
tion time set in Pn30A and then let the motor
coast.
n.X
Stopping Method for Forced Stops Reference
0 Apply the dynamic brake or coast the motor to a
stop (use the stopping method set in Pn001 =
n.X).
Ä Chap. 7.14.3
‘Stopping
Method Selec-
tion for Forced
Stops’
page 258
1 Decelerate the motor to a stop using the torque set
in Pn406 as the maximum torque. Use the setting
of Pn001 = n.X for the status after stopping.
2 Decelerate the motor to a stop using the torque set
in Pn406 as the maximum torque and then let the
motor coast.
3 Decelerate the motor to a stop using the decelera-
tion time set in Pn30A. Use the setting of Pn001 =
n.X for the status after stopping.
4 Decelerate the motor to a stop using the decelera-
tion time set in Pn30A and then let the motor
coast.
n.X
Reserved parameter (Do not change.)
n.X
Reserved parameter (Do not change.)
Sigma-7 Series SERVOPACKs
Parameter and Object Lists
List of Parameters > List of Parameters
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 668