YASKAWA Sigma-7 SGD7S Series - Page 669

Param-
eter No.
Size Name Setting
Range
Setting
Unit
Default
Setting
Appli-
cable
Motors
When
Enabled
Classifi-
cation
Refer-
ence
Pn00B 2 Application
Function
Selections B
0000h to
1121h
– 0000h All After
restart
Setup -
n.X
Operator Parameter Display Selection Reference
0 Display only setup parameters.
Ä Chap. 6.2.2
‘Classifications
of SERVO-
PACK Parame-
ters’ page 131
1 Display all parameters.
n.X
Motor Stopping Method for Group 2 Alarms Reference
0 Stop the motor by setting the speed reference to 0.
Ä Chap. 6.13.2
‘Stopping
Method for
Servo OFF’
page 174
1 Apply the dynamic brake or coast the motor to a
stop (use the stopping method set in Pn001 =
n.X).
2
Set the stopping method with Pn00A = n.X.
n.X
Power Input Selection for Three-phase SERVOPACK Reference
0 Use a three-phase power supply input.
Ä Chap. 6.3.3
‘Single-phase
AC Power
Supply Input/
Three-phase
AC Power
Supply Input
Setting’
page 144
1 Use a three-phase power supply input and as a
single-phase power supply input.
n.X
Reserved parameter (Do not change.)
Param-
eter No.
Size Name Setting
Range
Setting
Unit
Default
Setting
Appli-
cable
Motors
When
Enabled
Classifi-
cation
Refer-
ence
Pn00C 2 Application
Function
Selections C
0000h to
0131h
– 0000h – After
restart
Setup
Ä Chap.
8.7.4 ‘Test
without a
Motor’
page 288
Sigma-7 Series SERVOPACKs
Parameter and Object Lists
List of Parameters > List of Parameters
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 669