YASKAWA Sigma-7 SGD7S Series - Page 672

n.X
Reserved parameter (Do not change.)
n.X
Reserved parameter (Do not change.)
Param-
eter No.
Size Name Setting
Range
Setting
Unit
Default
Setting
Appli-
cable
Motors
When
Enabled
Classifi-
cation
Refer-
ence
Pn040 2 Reserved
parameter
(Do not
change.)
0000h to
2111h
– 0000h – – – –
Param-
eter No.
Size Name Setting
Range
Setting
Unit
Default
Setting
Appli-
cable
Motors
When
Enabled
Classifi-
cation
Refer-
ence
Pn080 2 Application
Function
Selections 80
0000h to
1111h
– 0000h Linear After
restart
Setup –
n.X
Polarity Sensor Selection Reference
0 Use polarity sensor.
Ä Chap. 6.9
‘Polarity Sensor
Setting’
page 156
1 Do not use polarity sensor.
n.X
Motor Phase Sequence Selection Reference
0 Set a phase-A lead as a phase sequence of U, V,
and W.
Ä Chap. 6.8
‘Selecting the
Phase
Sequence for a
Linear Servo-
motor’
page 154
1 Set a phase-B lead as a phase sequence of U, V,
and W.
n.X
Reserved parameter (Do not change.)
n.X
Calculation Method for Maximum Speed or Encoder
Output Pulses
Reference
0 Calculate the encoder output pulse setting for a
fixed maximum speed.
Ä Chap. 18.3.3
‘Corresponding
SERVOPACK
Monitor Display
Function
Names’
page 763
1 Calculate the maximum speed for a fixed encoder
output pulse setting.
Sigma-7 Series SERVOPACKs
Parameter and Object Lists
List of Parameters > List of Parameters
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 672