121
Symbologies
Introduction
You can program the scanner to perform various functions, or activate different features. This chapter describes
symbology features and provides programming barcodes for selecting these features.
The scanner ships with the settings shown in Table 13 on page 122 (also see Parameter Defaults for all defaults).
If the default values suit requirements, programming is not necessary.
Setting Parameters
To set feature values, scan a single barcode or a short barcode sequence. The settings are stored in non-volatile
memory and are preserved even when the scanner powers down.
If not using a USB cable, select a host type (see each host chapter for specific host information) after the power-up
beeps sound. This is only necessary upon the first power-up when connected to a new host.
To return all features to default values, see Default Parameters on page 59. Throughout the programming barcode
menus, asterisks (
*) indicate default values.
NOTE: Most computer monitors allow scanning barcodes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where you can see the barcode clearly, and
bars and/or spaces do not merge.
*Enable Parameter
Feature/option* Indicates default
To Next Page
Loading...
Need help?
General
