Zebra DS9908 Product Reference Guide

USB Interface
228
2. Plug the series A connector in the USB host or hub, or plug the PowerPlus connector in an available port of the
IBM SurePOS terminal.
3. The scanner automatically detects the host and uses the default USB device type. If the default (*) does not
meet your requirements, select another USB device type by scanning the appropriate barcode from USB
Device Type on page 230.
4. On first installation when using Windows, the software may prompt to select or install the Human Interface
Device driver. To install this driver, provided by Windows, click Next at all choices and click Finished on the
last choice. The scanner powers up during this installation.
5. To modify any other parameter options, scan the appropriate barcodes in this chapter.
If problems occur with the system, see Troubleshooting on page 48.
USB Parameter Defaults
Table 14 lists defaults for USB host parameters. Change these values in one of two ways:
• Scan the appropriate barcodes in this chapter. The new value replaces the standard default value in
memory. To recall default parameter values, see Default Parameters on page 59.
• Configure the scanner using the 123Scan configuration program. See 123Scan and Software Tools.
NOTE: Interface cables vary depending on configuration. The connectors illustrated in Figure 15 are examples
only. The connectors may be different than those illustrated, but the steps to connect the scanner are
the same.
NOTE: See Parameter Defaults for all user preference, host, symbology, and miscellaneous default
parameters.
Table 14 USB Interface Parameter Defaults
Parameter Default Page Number
USB Host Parameters
USB Device Type USB Keyboard HID 230
Symbol Native API (SNAPI) Status Handshaking Enable 232
USB Keystroke Delay No Delay 232
USB Caps Lock Override Disable 233
Barcodes with Unknown Characters Send Barcodes with Unknown
Characters
233
USB Convert Unknown to Code 39 Disable 234
USB Fast HID Enable 234
USB Polling Interval 3 msec 235
Keypad Emulation Enable 237
Quick Keypad Emulation Enable 237

Zebra DS9908 Specifications

General

Sealing	IP52
Scan Technology	Array Imager
Scan Rate	Up to 240 in./610 cm per second
Humidity	5% to 95% RH, non-condensing
Decode Capability	1D, 2D
Connectivity	USB, RS-232, Keyboard Wedge
Image Sensor	1280 x 800
Drop Specification	Multiple 5 ft./1.5 m drops to concrete
Operating Temperature	14°F to 122°F (-10°C to 50°C)
Light Source	LED
Storage Temperature	-40°F to 158°F (-40°C to 70°C)