User Preferences & Miscellaneous Options
77
Timeout Between Decodes, Different Symbols
Parameter # 144
SSI # 90h
Use this option in presentation mode or Continuous Barcode Read to control the time the scanner waits before
decoding a different symbol. It is programmable in 0.1 second increments from 0.1 to 9.9 seconds. The default is
0.1 seconds.
To select the timeout between decodes for different symbols, scan the following barcode, and then scan two
barcodes from Numeric Barcodes that correspond to the desired interval, in 0.1 second increments.
Triggered Timeout, Same Symbol
Parameter # 724 (SSI # F1h D4h)
Scan Enable Triggered Timeout, Same Symbol below to apply Timeout Between Decodes, Same Symbol
(parameter #137 on page 76) in hand-held trigger mode. Subsequent scans of Enable Triggered Timeout, Same
Symbol are ignored until Timeout Between Decodes, Same Symbol expires.
NOTE: Timeout Between Decodes, Different Symbols cannot be greater than or equal to the Decode Session
Timeout.
Timeout Between Decodes, Different Symbols
NOTE: This feature does not apply to Timeout Between Decodes, Different Symbols.
NOTE: Timeout Between Decodes, Same Symbol cannot be greater than or equal to the Time Delay to Low
Power Mode (parameter #146 on page
67).
Enable Triggered Timeout, Same Symbol
(1)
* Disable Triggered Timeout, Same Symbol
(0)
To Next Page
Loading...
Need help?
General
