SSI Interface
260
Host RTS Line State
Parameter # 154
SSI # 9Ah
Scan one of the following barcodes to set the expected idle state of the Serial Host RTS line.
The SSI interface is used with host applications which also implement the SSI protocol. However, you can use the
scanner in a "scan-and-transmit" mode to communicate with any standard serial communication software on a host
PC (see Decode Data Packet Format on page 261). If transmission errors occur in this mode, the host PC may be
asserting hardware handshaking lines which interfere with the SSI protocol. Scan the High barcode to address this
problem.
*Low
(0)
High
(1)
To Next Page
Loading...