EasyManuals Logo

Zebra DS9908 Product Reference Guide

Zebra DS9908
546 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #288 background imageLoading...
Page #288 background image
288
IBM Interface
Introduction
This chapter describes how to set up the scanner with an IBM 468X/469X host.
The scanner ships with the settings shown in Table 22 on page 290 (also see Parameter Defaults for all defaults).
If the default values suit requirements, programming is not necessary.
Setting Parameters
To set feature values, scan a single barcode or a short barcode sequence. The settings are stored in non-volatile
memory and are preserved even when the scanner powers down.
To return all features to default values, scan Set Factory Defaults on page 59. Throughout the programming
barcode menus, asterisks (
*) indicate default values.
Scanning Sequence Examples
In most cases scanning one barcode sets the parameter value. For example, to select the Port 9B address, scan
the Hand-held Scanner Emulation (Port 9B) barcode under Port Address on page 291. The scanner issues a
fast warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters require scanning several barcodes. See the parameter descriptions for this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
NOTE: Most computer monitors allow scanning barcodes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where you can see the barcode clearly, and
bars and/or spaces do not merge.
*Enable Parameter
Feature/option* Indicates default

Table of Contents

Other manuals for Zebra DS9908

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zebra DS9908 and is the answer not in the manual?

Zebra DS9908 Specifications

General IconGeneral
SealingIP52
Scan TechnologyArray Imager
Scan RateUp to 240 in./610 cm per second
Humidity5% to 95% RH, non-condensing
Decode Capability1D, 2D
ConnectivityUSB, RS-232, Keyboard Wedge
Image Sensor1280 x 800
Drop SpecificationMultiple 5 ft./1.5 m drops to concrete
Operating Temperature14°F to 122°F (-10°C to 50°C)
Light SourceLED
Storage Temperature-40°F to 158°F (-40°C to 70°C)

Related product manuals