Symbologies
165
Code 11
Parameter # 10
SSI # 0Ah
Scan one of the following barcodes to enable or disable Code 11
Set Lengths for Code 11
L1 = Parameter # 28
SSI # 1Ch
L2 = Parameter # 29
SSI # 1Dh
The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s)
the code contains. Set lengths for Code 11 to any length, one or two discrete lengths, or lengths within a specific
range. The default is Length Within Range: 4 to 55.
Scan one of the following barcodes to select a length option:
• One Discrete Length - Decode only Code 11 symbols containing a selected length. Select the length
using the barcodes in Numeric Barcodes. For example, to decode only Code 11 symbols with 14
characters, scan Code 11 - One Discrete Length, and then scan 1, 4. To correct an error or change the
selection, scan Cancel on page 426.
• Two Discrete Lengths - Decode only Code 11 symbols containing either of two lengths. Select
lengths using the barcodes in Numeric Barcodes. For example, to decode only Code 11 symbols
containing either 2 or 14 characters, scan Code 11 - Two Discrete Lengths, and then scan 0, 2, 1, 4.
To correct an error or change the selection, scan Cancel on page 426.
• Length Within Range - Decode Code 11 symbols with a specific length range. Select lengths using
the barcodes in Numeric Barcodes. For example, to decode Code 11 symbols containing between 4
and 12 characters, scan Code 11 - Length Within Range, and then scan 0, 4, 1, 2. To correct an error or
change the selection, scan Cancel on page 426.
• Any Length - Decode Code 11 symbols containing any number of characters within the scanner’s
capability.
Enable Code 11
(1)
*Disable Code 11
(0)
NOTE: When setting lengths, enter a leading zero for single digit numbers
To Next Page
Loading...
Need help?
General
