Zebra DS9908 Product Reference Guide

Symbologies
122
Scanning Sequence Examples
In most cases, scanning one barcode sets the parameter value. For example, to transmit barcode data without the
UPC-A check digit, scan the Do Not Transmit UPC-A Check Digit barcode under Transmit UPC-A Check Digit on
page 140. The scanner issues a fast warble beep and the LED turns green, signifying a successful parameter
entry.
Other parameters require scanning several barcodes. See the parameter descriptions for this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
Symbology Parameter Defaults
Table 13 lists defaults for all symbology parameters. Change these values in one of two ways:
• Scan the appropriate barcodes in this chapter. The new value replaces the standard default value in
memory. To recall the default parameter values, see Default Parameters on page 59.
• Configure the scanner using the 123Scan configuration program. See 123Scan and Software Tools.
NOTE: See Parameter Defaults for all user preference, host, symbology, and miscellaneous default
parameters.
Table 13 Symbology Parameter Defaults
Parameter
Parameter
Number
1
SSI Number
2
Default
Page
Number
Enable/Disable All Code Types
129
1D Symbologies
UPC/EAN/JAN
UPC-A 1 01h Enable 129
UPC-E 2 02h Enable 130
UPC-E1 12 0Ch Disable 130
EAN-8/JAN 8 4 04h Enable 131
EAN-13/JAN 13 3 03h Enable 131
Bookland EAN 83 53h Disable 132
Bookland ISBN Format 576 F1h 40h ISBN-10 133
ISSN EAN 617 F1h 69h Disable 134
Decode UPC/EAN/JAN Supplementals
(2 and 5 digits)
16 10h Ignore 135
1. Parameter number decimal values are used for programming via RSM commands.
2. SSI number hex values are used for programming via SSI commands.

Zebra DS9908 Specifications

General

Brand	Zebra
Model	DS9908
Category	Barcode Reader
Language	English