User Preferences & Miscellaneous Options
88
FN1 Substitution Values
Key Category Parameter # 103
Key Category SSI # 67h
Decimal Value Parameter # 109
Decimal Value SSI # 6Dh
Keyboard wedge and USB HID keyboard hosts support a FN1 substitution feature. Enabling this substitutes any
FN1 character (0x1b) in an EAN128 barcode with a value. This value defaults to 7013 <CR><LF> (Enter key).
When using host commands to set the FN1 substitution value, set the key category parameter to 1, and then set
the 3-digit keystroke value. See the ASCII Character Set table for the current host interface for the desired value.
To select a FN1 substitution value via barcode menus:
1. Scan the following barcode.
2. Locate the keystroke desired for FN1 Substitution in the ASCII Character Set table for the current host
interface, and enter the 4-digit ASCII value by scanning four barcodes from Numeric Barcodes.
To correct an error or change the selection, scan Cancel.
To enable FN1 substitution for USB HID keyboard, scan Enable USB Keyboard FN1 Substitution on page 238.
To enable FN1 substitution for keyboard wedge, scan Enable FN1 Substitution on page 302.
Set FN1 Substitution Value
To Next Page
Loading...
Need help?
General
