RS-232 Interface
286
Nixdorf Beep/LED Options
If you selected Nixdorf Mode B, scan one of the following barcodes to indicate when the scanner beeps and turns
on its LED after a decode.
Barcodes with Unknown Characters
Unknown characters are characters the host does not recognize. Scan Send Barcodes With Unknown
Characters to send all barcode data except for unknown characters. The scanner issues no error beeps.
Scan Do Not Send Barcodes With Unknown Characters to send barcode data up to the first unknown character.
The scanner issues an error beep.
*Normal Operation
(Beep/LED Immediately After Decode)
Beep/LED After Transmission
Beep/LED After CTS Pulse
*Send Barcodes With Unknown Characters
Do Not Send Barcodes With Unknown Characters
To Next Page
Loading...