User Preferences & Miscellaneous Options
57
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
User Preferences/Miscellaneous Options Parameter Defaults
Table 8 lists defaults for user preferences parameters. Change these values in one of two ways:
• Scan the appropriate barcodes in this chapter. The new value replaces the standard default value in
memory. To recall default parameter values, see Default Parameters on page 59.
• Configure the scanner using the 123Scan
configuration program. See 123Scan and Software Tools.
NOTE: See Parameter Defaults for all user preference, host, symbology, and miscellaneous default parameters.
Table 8 User Preferences Parameter Defaults
Parameter
Parameter
Number
1
SSI
Number
2
Default
Page
Number
Standard User Preferences
Set Default Parameter N/A N/A N/A 59
Parameter Barcode Scanning 236 ECh Enable 60
Beep After Good Decode 56 38h Enable 60
Beep Volume 140 8Ch High 61
Beep Tone 145 91h Medium 62
Beep Duration 628 F1h 74h Short 64
Suppress Power Up Beeps 721 F1h D1h Do Not Suppress 64
Direct Decode Indicator 859 F2h 5Bh Disable 65
Low Power Mode 128 80h Disable 66
Time Delay to Low Power Mode 146 92h 1 Hour 67
Trigger Mode (or Hand-held Trigger
Mode)
138 8Ah Auto Aim 69
Hands-free Mode 630 F1h 76h Enable 70
Pickup Activation 1927 F8h 07h 87h Touch Plus 71
Hand-held Decode Aiming Pattern 306 F0h 32h Enable 72
Presentation (Hands-free) Decode Aiming
Pattern
590 F1h 4Eh Disable Presentation
(Hands-free) Decode
Aiming Pattern
73
1. Parameter number decimal values are used for programming via RSM commands.
2. SSI number hex values are used for programming via SSI commands.
To Next Page
Loading...
Need help?
General
