User Preferences & Miscellaneous Options
76
Decode Session Timeout
Parameter # 136
SSI # 88h
This parameter sets the maximum time decode processing continues during a scan attempt. It is programmable in
0.1 second increments from 0.5 to 9.9 seconds. The default timeout is 9.9 seconds.
To set a Decode Session Timeout, scan the following barcode, and then scan two barcodes from Numeric
Barcodes that correspond to the desired on time. Enter a leading zero for single digit numbers. For example, to set
a Decode Session Timeout of 0.5 seconds, scan this barcode, and then scan the 0 and 5 barcodes. To correct an
error or change the selection, scan Cancel
.
Timeout Between Decodes, Same Symbol
Parameter # 137
SSI # 89h
Use this option in presentation mode or Continuous Barcode Read mode to prevent the scanner from continuously
decoding the same barcode when it is left in the scanner’s field of view. The barcode must be out of the field of
view for the timeout period before the scanner reads the same consecutive symbol. It is programmable in 0.1
second increments from 0.0 to 9.9 seconds. The default interval is 0.5 seconds.
To select the timeout between decodes for the same symbol, scan the following barcode, and then scan two
barcodes from Numeric Barcodes that correspond to the desired interval, in 0.1 second increments.
Decode Session Timeout
Timeout Between Decodes, Same Symbol
To Next Page
Loading...
Need help?
General
