Symbologies
135
Decode UPC/EAN/JAN Supplementals
Parameter # 16
SSI # 10h
Supplementals are barcodes appended according to specific format conventions (e.g., UPC A+2, UPC E+2, EAN
13+2). The following options are available:
• Decode UPC/EAN/JAN with Supplementals Only - The scanner only decodes UPC/EAN/JAN symbols
with supplemental characters, and ignores symbols without supplementals.
• Ignore UPC/EAN/JAN Supplementals - When presented with a UPC/EAN/JAN plus supplemental
symbol, the scanner decodes UPC/EAN/JAN and ignores the supplemental characters.
• Autodiscriminate UPC/EAN/JAN with Supplementals - The scanner decodes UPC/EAN/JAN symbols
with supplemental characters immediately. If the symbol does not have a supplemental, the scanner must
decode the barcode the number of times set via UPC/EAN/JAN Supplemental Redundancy on page 138
before transmitting its data to confirm that there is no supplemental.
Select one of the following Supplemental Mode options to immediately transmit EAN-13 barcodes starting
with that prefix that have supplemental characters. If the symbol does not have a supplemental, the scanner
must decode the barcode the number of times set via UPC/EAN/JAN Supplemental Redundancy on page 138
before transmitting the data to confirm that there is no supplemental. The scanner transmits UPC/EAN/JAN
barcodes that do not have that prefix immediately.
• Enable 378/379 Supplemental Mode
• Enable 978/979 Supplemental Mode
• Enable 977 Supplemental Mode
• Enable 414/419/434/439 Supplemental Mode
• Enable 491 Supplemental Mode
• Enable Smart Supplemental Mode - This applies to EAN-13 barcodes starting with any prefix listed
previously.
• Supplemental User-Programmable Type 1 - This applies to EAN-13 barcodes starting with a 3-digit
user-defined prefix. Set this using User-Programmable Supplementals on page 138.
• Supplemental User-Programmable Type 1 and 2 - This applies to EAN-13 barcodes starting with either
of two 3-digit user-defined prefixes. Set the prefixes using User-Programmable Supplementals on page
138.
• Smart Supplemental Plus User-Programmable 1 - This applies to EAN-13 barcodes starting with any
prefix listed previously or the prefix set using User-Programmable Supplementals on page 138.
• Smart Supplemental Plus User-Programmable 1 and 2 - This applies to EAN-13 barcodes starting with
any prefix listed previously or one of the two user-defined prefixes set using User-Programmable
Supplementals on page 138.
NOTE: If you select 978/979 Supplemental Mode and are scanning Bookland EAN barcodes, see
Bookland EAN on page 132 to enable Bookland EAN, and select a format using Bookland ISBN
Format on page 133.
To Next Page
Loading...
Need help?
General
