95
Imager Preferences
Introduction
You can program the imager to perform various functions, or activate different features. This chapter describes
image capture preference features and provides programming barcodes for selecting these features.
The imager ships with the settings shown in Table 9 on page 96 (also see Parameter Defaults for all defaults). If
the default values suit requirements, programming is not necessary.
Setting Parameters
To set feature values, scan a single barcode or a short barcode sequence. The settings are stored in non-volatile
memory and are preserved even when the imager powers down.
To return all features to default values, scan the Set Factory Defaults on page 59. Throughout the programming
barcode menus, asterisks (
*) indicate default values.
NOTE: Only the Symbol Native API (SNAPI) with Imaging interface supports image capture. See USB Device
Type on page 230 to enable this host.
NOTE: Most computer monitors allow scanning barcodes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where you can see the barcode clearly, and
bars and/or spaces do not merge.
*Enable Parameter
(1)
Feature/option
* Indicates default
Option value
To Next Page
Loading...
Need help?
General
