EasyManuals Logo

Zebra DS9908 Product Reference Guide

Zebra DS9908
546 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
User Preferences & Miscellaneous Options
59
Standard User Preferences
Default Parameters
Scan one of the following barcodes to reset the scanner to its default settings as follows:
Restore Defaults resets all default parameters as follows:
If you configured custom default parameter values via the Write to Custom Defaults barcode,
scanning the Restore Defaults barcode restores these custom values.
If you did not configure custom default parameter values, scanning the Restore Defaults barcode
restores the factory default values. See Parameter Defaults for these values.
Set Factory Defaults clears all custom default values and sets the factory default values. See Parameter
Defaults for these values.
Write to Custom Defaults
To create a set of custom defaults, select the desired parameter values in this guide, and then scan Write to
Custom Defaults.
securPharm Decoding 1752 F8h 06h D8h Disable 91
securPharm Output Formatting 1753 F8h 06h D9h No Formatting 92
Table 8 User Preferences Parameter Defaults (Continued)
Parameter
Parameter
Number
1
SSI
Number
2
Default
Page
Number
1. Parameter number decimal values are used for programming via RSM commands.
2. SSI number hex values are used for programming via SSI commands.
Restore Defaults
Set Factory Defaults
Write to Custom Defaults

Table of Contents

Other manuals for Zebra DS9908

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zebra DS9908 and is the answer not in the manual?

Zebra DS9908 Specifications

General IconGeneral
SealingIP52
Scan TechnologyArray Imager
Scan RateUp to 240 in./610 cm per second
Humidity5% to 95% RH, non-condensing
Decode Capability1D, 2D
ConnectivityUSB, RS-232, Keyboard Wedge
Image Sensor1280 x 800
Drop SpecificationMultiple 5 ft./1.5 m drops to concrete
Operating Temperature14°F to 122°F (-10°C to 50°C)
Light SourceLED
Storage Temperature-40°F to 158°F (-40°C to 70°C)

Related product manuals