CKJ Decode Control
496
CJK Output Method to Windows Host
Parameter # 972
For a national standard encoded CJK barcode, select one of the following options for CJK output to a Windows
host:
• Universal CJK Output - This is the default universal CJK output method for US English IME or
Chinese/Japanese/Korean ASCII IME on a Windows host. This method converts CJK characters to
Unicode and emulates the characters when transmitting to the host. Use the Unicode Output Control
parameter to control Unicode output.
• Other options for CJK output - With the following methods, the scanner sends the CJK character
hexadecimal internal code (Nei Ma) value to the host, or converts the CJK character to Unicode and sends
the hexadecimal Unicode value to the host. When using these methods, the Windows host must select the
corresponding IME to accept the CJK character. See Unicode/CJK Decode Setup with Windows Host on
page 499.
• Japanese Unicode Output
• Simplified Chinese GBK Code Output
• Simplified Chinese Unicode Output
• Korean Unicode Code Output
• Traditional Chinese Big5 Code Output (Windows XP)
• Traditional Chinese Big5 Code Output (Windows 7)
• Traditional Chinese Unicode Code Output (Windows XP)
• Traditional Chinese Unicode Code Output (Windows 7)
NOTE: To support universal CJK output, set up the registry table for the Windows host. See Unicode/CJK
Decode Setup with Windows Host on page 499.
NOTE: The Unicode emulate output method depends on the host system (Windows XP or Windows 7).
*Universal CJK Output
(0)
Japanese Unicode Output
(34)
(For Japanese Unicode Output, select Simplified Chinese
Unicode IME on the Windows host)
To Next Page
Loading...
Need help?
General
