Getting Started
33
Mounting the Scanner
The optional multi-mount bracket is required when mounting the scanner to a table top or wall (or other vertical
surface). When mounting to a table top, use either screws or the adhesive pad. When mounting to a wall (or other
vertical surface) screws are required.
Table Top Mount With Adhesive Pad
Figure 5 Mounting With Adhesive On a Table Top
To mount the optional multi-mount bracket using the adhesive pad:
1. Clean the table top surface with Isopropyl alcohol to remove any dirt or debris.
2. Peel the corner of the paper liner off the tape on the bottom of the multi-mount bracket (Figure 5).
3. Press the bottom of the multi-mount bracket on the flat table top and apply uniform pressure for minimally 10
seconds to secure it to the surface (Figure 5).
4. Slide the base of the scanner into the bracket (Figure 7).
NOTE: When mounting to a table top screws are more secure than the adhesive pad.
To Next Page
Loading...