Zebra DS9908 - Page 419

Parameter Defaults
419
UPC Composite Mode 344 F0h 58h UPC Never Linked 205
Composite Beep Mode 398 F0h 8Eh Beep As Each Code Type is
Decoded
206
GS1-128 Emulation Mode for
UCC/EAN Composite Codes
427 F0h ABh Disable 206
2D Symbologies
PDF417 15 0Fh Enable
207
MicroPDF417 227 E3h Disable 207
Code 128 Emulation 123 7Bh Disable 208
Data Matrix 292 F0h 24h Enable
209
GS1 Data Matrix 1336 F8h 05h 38h Disable 209
Data Matrix Inverse 588 F1h 4Ch Inverse Autodetect 210
Decode Data Matrix Mirror Images 537 F1h 19h Auto 211
Maxicode 294 F0h 26h Disable 212
QR Code 293 F0h 25h Enable 212
GS1 QR 1343 F8h 05h 3Fh Enable
213
MicroQR 573 F1h 3Dh Enable 213
Linked QR Mode 1847 737h Linked QR Only 214
Aztec 574 F1h 3Eh Enable 215
Aztec Inverse 589 F1h 4Dh Inverse Autodetect 215
Han Xin 1167 F8h 04h 8Fh Disable 216
Han Xin Inverse 1168 F8h 04h 90h Regular 216
Grid Matrix 1718 F8h 06h B6h Disable 217
Grid Matrix Inverse 1719 F8h 06h B7h Regular Only 217
Grid Matrix Mirror 1736 F8h 06h C8h Regular Only 218
Macro PDF
Flush Macro PDF Buffer N/A N/A N/A
219
Abort Macro PDF Entry N/A N/A N/A 219
Table 29 Parameter Defaults (Continued)
Parameter
Parameter
Number
1
SSI
Number
2
Default
Page
Number
1. Parameter number decimal values are used for programming via RSM commands.
2. SSI number hex values are used for programming via SSI commands.