CAPINTEC, INC. CAPTUS
®
4000e
p-2 PREFACE July 16
• All-in-One Touchscreen Computer System
• CAP-MCA
• Printer
• Cables for connecting detector, printer, etc.
• 15 foot power cord with hospital grade plug
• Software and Documentation
• Windows 8.1 or later,
• CAPTUS
®
4000e Manual and Installation Disks or CDs
• Optional Well Counter with drilled Well Detector
MEDICAL EQUIPMENT SAFETY CLASSIFICATION
• CLASS I EQUIPMENT energized from an external power source
• TYPE B EQUIPMENT with applied part (Positioning Rod)
• Ordinary EQUIPMENT without protection against the ingress of water
• Suitable for CONTINUOUS OPERATION
• NOT suitable for use in the presence of a an FLAMMABLE ANAESTHETIC
MIXTURE WITH AIR or WITH OXYGEN OR NITROUS OXIDE
ELECTROMAGNETIC INTERFERENCE POTENTIAL
This equipment complies fully with interference immunity requirements of the standard IEC
60601-1-2 “Medical electrical equipment: Part 1: General safety requirements; 2.
Supplementary standard: Electromagnetic compatibility”.
This equipment generates radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to nearby devices.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference, the user is encouraged to try to correct the
interference by one of the following measures:
• Increase the separation between the equipment and the affected device.
• Plug the unit into an outlet on a circuit different from that which the affected device is
connected.
If this fails to correct the problem, please contact Capintec’s only Authorized Service Center.
To Next Page
Loading...