Capintec CAPTUS 4000e - Creating a Report

CAPINTEC, INC. CAPTUS
®
4000e
December 15 CUSTOM PROTOCOLS 15-23
Figure 15-34
Calculations may be made using data from the Patient Data sheet. For example, if
the count time for the first test is needed, it would be referred to as ‘Patient Data’!I10.
Creating a Report
To set up a report, select the Report tab at the bottom of the workbook. The Report
sheet will be shown. Information can be taken from the Patient Data sheet, the
Protocol Data sheet and the Formulas sheet.
An example of the start of a report is shown in Figure 15-35.
Figure 15-35