Capintec CAPTUS 4000e - CHAPTER 16 CLEANING AND MAINTENANCE; INTRODUCTION; CLEANING and DISINFECTING; PREVENTIVE MAINTENANCE

CAPINTEC, INC. CAPTUS
®
4000e
July 16 CLEANING AND MAINTENANCE 16-1
CHAPTER 16
CLEANING AND MAINTENANCE
INTRODUCTION ............................................................................................ 16-1
CLEANING and DISINFECTING .................................................................... 16-2
Cleaning Instructions ................................................................................ 16-2
Disinfecting Instructions .......................................................................... 16-4
PREVENTIVE MAINTENANCE ...................................................................... 16-4
DISPOSAL ..................................................................................................... 16-5
SERVICING .................................................................................................... 16-6
Collimator Block Inspection ..................................................................... 16-6
Spring-Arm Inspection .............................................................................. 16-7
Computer Battery Replacement ............................................................... 16-9
FUSE SERVICING.......................................................................................... 16-9
Power Line Fuses ...................................................................................... 16-9
Computer and Printer Fuses ................................................................... 16-11
ACCESSORIES AND REPLACEMENT PARTS ........................................... 16-12
SHIPPING ..................................................................................................... 16-13
INTRODUCTION
This chapter provides the information necessary for the user to perform the basic
maintenance of instrument cleaning, fuse replacement and general preventative
maintenance. There are no internal adjustments or calibration settings that may be done by
the user within the conditions of the warranty.
CAUTION: REFER ALL SERVICING TO A QUALIFIED SERVICE
REPRESENTATIVE!
It is recommended that periodic (every three to five years) re-calibration of the CAPTUS
®
4000e be performed only by Capintec’s Authorized Service Center to guarantee the
instrument’s high reliability is maintained. Contact Capintec’s only Authorized Service Center
for servicing or re-calibration at (800) ASK-4CRC.