CAPINTEC, INC. CAPTUS
®
4000e
December 15 CUSTOM PROTOCOLS 15-7
19. If special instructions are to be displayed for the measurement, type the instructions
in the Instructions for Sample text box.
20. When all the fields are entered, select the Next button or press ALT+N to enter data
for the next measurement. For the last measurement, select the Done button or press
ALT+D to end the protocol entry.
Note: The number of measurement setup screens that appear depends upon the
number of measurements entered in step 3 above.
Viewing Protocols
Select the View button on Figure 15-2 Main Protocol Screen. You can then step through the
screens described in the Adding Protocols section and view the details of the protocol.
Deleting Protocols
Deleting Selected Protocols
On the Main Protocol Screen, select one or more protocols for deletion by clicking in
the check box to the left of the protocol name in the Protocols box. A check should
appear in the check box to indicate it has been selected. The Protocol can also be
selected by first highlighting the desired Protocol by clicking and then double-clicking
anywhere in the grid to place a check in the box. To deselect a protocol, click in its
check box again or double-click anywhere in the grid while the desired Protocol is
highlighted and the check will be removed from the check box.
Note: The status of a check box can be toggled by quickly double-clicking the
desired item.
Select the Delete button on Figure 15-2 Main Protocol Screen. A message window
will appear prompting to verify the deletion(s).
Note: If there is a patient test in progress using the selected protocol, the protocol
cannot be deleted.
Deleting All Protocols
Select the Delete All button on Figure 15-2 Main Protocol Screen. A message
window will appear prompting to verify the deletion(s).
Note: If there is a patient test in progress using the one of the protocols, that
protocol cannot be deleted.
Selecting the Excel Workbook for the Protocol
Note: Before selecting a workbook for the protocol, the protocol must first be set up in the
CAPTUS
®
4000e program, and then the steps outlined in the section CUSTOM
PROTOCOLS EXCEL WORKBOOK on page 15-16 must be performed.
To Next Page
Loading...