CAPINTEC, INC. CAPTUS
®
4000e
August 15 TIME ACTIVITY ANALYSIS 12-1
CHAPTER 12
TIME ACTIVITY ANALYSIS
INTRODUCTION ............................................................................................ 12-1
SETTING UP PARAMETERS ........................................................................ 12-2
MAKING MEASUREMENTS .......................................................................... 12-5
Saving the Results .................................................................................... 12-8
VIEWING PREVIOUSLY SAVED RESULTS .................................................. 12-9
INTRODUCTION
Time Activity Analysis (TAA) permits the user to make repeated measurements at timed
intervals. It provides control over Regions of Interest (ROI), live time and real time for
counting. The data can be viewed as raw counts, decay corrected or both and displayed
either in a graph or tabular form.
To access this module, select the Time Activity Analysis button or press Alt+T on the
CAPTUS
®
4000e Main screen. Figure 12-1 Time Activity Analysis screen will appear. The
functions at the bottom of the screen are disabled until the required parameters have been
entered. When counting is started, a live spectrum is displayed in the upper half of the
screen. The elapsed real and live times are displayed at the upper right of the screen as the
counting progresses. Below the displayed time, there are options for viewing and displaying
the data.
To Next Page
Loading...