ENGINE CONTROLS 1F–315
DAEWOO M-150 BL2
Important: A special anti–seize compound is used on
the oxygen sensor threads. This compound consists of
a liquid graphite and glass beads. The graphite will burn
away, but the glass beads will remain, making the sen-
sor easier to remove. New or service sensors will al-
ready have the compound applied to the threads. If a
sensor is removed from any engine and if for any reason
it is to be reinstalled, the threads must have anti–seize
compound applied before reinstallation.
2. Install the oxygen sensor.
Tighten
Tighten the oxygen sensor to 35~44 NSm (26~33 lb-
ft).
MAA1F480
EXHAUST GAS RECIRCULATION
VALVE
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the air cleaner assembly.
3. Disconnect the electric exhaust gas recirculation
(EEGR) valve connector.
D21F008
KNOCK SENSOR
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the starter. Refer to Section 1E, Engine
Electrical.
3. Disconnect the electrical connector at the knock sen-
sor (1).
D21F009
4. Remove the knock sensor.
D Remove the knock sensor retaining bolt (1).
D Remove the knock sensor.
To Next Page
Loading...
