4A –12 HYDRAULIC BRAKES
DAEWOO M-150 BL2
D24D005
Installation Procedure
1. Install the brake pedal with pad, spring, bushings, and
cushion.
2. Install the bolt mounting brake pedal bracket in the
engine compartment.
Tighten
Tighten the bolt to 18–26 NSm (13–20 lb-ft).
3. Install the canister. Refer to Section 1F, Engine Con-
trols.
D24D006
4. Install the brake pedal with the snap rings.
5. Install the bolts and nuts mounting brake pedal brack-
et.
Tighten
D Tighten the bolts mounting brake pedal bracket to
18–26 NSm (13–20 lb-ft).
D Tighten the nuts mounting brake pedal bracket to
18–26 NSm (13–20 lb-ft).
D24D007
6. Install the stoplamp switch with the bracket and the
bolts.
Tighten
Tighten the mounting bolts to 9–12 NSm (80–106 lb-
in.)
7. Connect the brake pedal rod to the power booster.
Refer to Section 4C, Power Booster.
8. Install the instrument panel assembly. Refer to Sec-
tion 9E, Instrument/Driver Information.
To Next Page
