Danfoss VLT series Programming Guide

3.3.6 Cooling Fans 93
3.4 External Encoder and Guide Value
93
3.5 Signal Tracing
93
3.6 Multiple Device ID Assignment
93
3.7 Software Version
93
3.8 Firmware Update
93
4 Local Control Panel (LCP) Operation
94
4.1 Overview
94
4.2 Local Control Panel (LCP) Layout
94
4.3 Graphical User Interface
96
4.3.1 Supported Languages 96
4.3.2 LCP Display 96
4.3.3 Status Menu (Auto On Mode) 96
4.3.3.1 Default Readouts for ISD 510 Servo Drive 97
4.3.3.2 Default Readouts for SAB 97
4.3.3.3 Alarms and Warnings 98
4.3.4 Main Menu 98
4.3.4.1 Displaying and Editing Values 99
4.3.4.2 ISD 510 Drive Menu 100
4.3.4.3 SAB Menu 100
4.3.5 Hand On Mode 101
4.3.5.1 Servo Drive 101
4.3.5.2 SAB 104
4.3.6 Alarm Log 104
4.4 Keys
104
4.4.1 Status Key 104
4.4.2 Quick Menu Key 104
4.4.3 Main Menu Key 104
4.4.4 Alarm Log Key 105
4.4.5 Back Key 105
4.4.6 Cancel Key 105
4.4.7 Info Key 105
4.4.8 OK Key 106
4.4.9 Hand On Key 106
4.4.10 O Key 106
4.4.11 Auto On Key 106
4.4.12 Reset Key 106
4.4.13 Up [
▲
] and Down [
▼
] Keys
106
4.4.14 Left [
◀
] and Right [
▶
] Keys
107
Contents Programming Guide
MG36D102 Danfoss A/S © 01/2017 All rights reserved. 3

Danfoss VLT series Specifications

General

Series	VLT
Category	DC Drives
Output Voltage	0-100% of input voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Overtemperature, Short Circuit, Ground Fault
Communication Interfaces	Profibus, CANopen
Enclosure Rating	IP20, IP21, IP55, IP66
Cooling Method	Forced Air Cooling, Convection Cooling
Control Mode	Sensorless Vector, Closed Loop Vector
Ambient Temperature	-10°C to +50°C (14°F to 122°F)