Dell 3115CN - Replacement Flows

3 - 6
Chapter 3 Removal and Replacement Procedures (RRPs)
Version 1 2006.11.28
Replacement Flows
The components not connected with arrows in the flow below can be replaced independently.
However, the rear cover is an exception when it was removed together with other parts.
Attaching 550 SHEET PAPER TRAY
550 SHEET FEEDER ASSEMBLY (
Replacement 4)550 TRAY REAR COVER ( Replacement 3)
550 TRAY SEPARATOR ROLLER (
Replacement 1)
550 TRAY FEED ROLLER (
Replacement 2)
550 SHEET FEEDER ASSEMBLY Replacement FLOW
PRINTER(MPF Roller &FEED Roller) Replacement FLOW
Attaching 250 SHEET PAPER TRAY
FEED ROLLER (Replacement5) MPF ROLLER (Replacement6))
SEPARATOR ROLLER (Replacement7)
MPF SEPARATOR ROLLER ASSEMBLY (Replacement8)
REAR COVER (Replacement73)
COVER BOTTOM (Replacement72)
BOX ASSY PRT AIO (Replacement62)
COVER POLE IN R (Replacement71)
COVER POLE R (Replacement70)
COVER POLE IN L (Replacement65)COVER POLE IN L (Replacement65)
COVER POLE IN R (Replacement71)
COVER BOTTOM (Replacement72)
REAR COVER (Replacement73)
COVER POLE L (Replacement64)
POWER SWITCH (Replacement69)
BOX ASSY FAX AIO (Replacement60)
PWBA FAX (Replacement59)
PWBA FAX (Replacement59)
PWBA HYUI (Replacement58)
PRINTER(Rear Pole Side) Replacement FLOW
ELECTRONIC SUB-SYSTEM CONTROL BOARD (Replacement61)
LOW VOLTAGE POWER SUPPLY (Replacement57)
MULTI PROTOCOL CARD (Replacement46)
MEMORY CARD (Replacement47)