Dell 3115CN - Functions; Recording System; Exposure System; Development System

8 – 8
Chapter 8 Printer Specifications
Version 1 2006.11.21
4. Functions
4.1 Recording System
Electro-photographic system employing OPC drum and direct transfer by the transport belt
4.2 Exposure System
Semiconductor four laser beams scanning system
4.3 Development System
Development with dry type 2-component developer
4.4 Fixing System
Thermal fixing system by Free Belt Nip Fusing (FBNF)
4.5 Resolution
- Main scanning direction:by the printer controller
- Sub scanning direction:600 dots/25.4mm (fixed)
4.6 Operation Mode
The printer can be operated in either of 4 operation modes. The modes are switched over by command
from the printer controller or change of printer operation, etc.
Proceeding from power ON, low power mode or sleep mode to standby mode will take place after going
through a warm up stage.
- Running mode (Printing)
State in running or recording operation
Fixing system: Held at operating temperature.
Exposure system: Operating status
Recording system: Operating status
- Running mode (Scanning)
Exposure system: Operating status
- Ready mode
Ready state
Fixing system: Held at ready temperature.
Exposure system: Stop status
Recording system: Stop status
- Low power mode
Complete resting state. 35W or less at sleep mode.
18W or less at deep sleep mode.
Fixing system: Stop status
Exposure system: Stop status
Recording system: Stop status