Dell 3115CN - Digital Output (DO) Test; Executing Digital Output (DO) Test

2 - 29
Chapter 2 Operation of Diag.
Version 1 2006.11.21
4.3.3 Digital Output (DO) Test
This function checks whether the DO components operate.
When the interlock is opened while the DO test is performed, each component ends to operate.
In this Test Mode, each DO component can be turned individually. Therefore it allows
the customer to check a component' s operation from outside, and judge whether the
component is normal or not.
When all the diag. functions are stopped, all the DO components can be turned off.
DO test can make each of the DO components operate simultaneously.
When a paper jam or PQ problem is occurred, or an error message or code is displayed, this test
enables to look for the broken or damaged parts.
Test result: NG (Go to each FIP or replace the parts.)
OK (Turn off/on the main power.)
4.3.4 Executing digital output (DO) test
1) Turn off the power.
2) Turn on the power while holding down “  ” and “  ” keys.
3) Release the fingers from these keys when “Please wait...” is displayed.
4) The “Customer Mode”, “FAX Scanner Diag” and “Printer Diag” are displayed. (Entered the
Diag. mode.)
5) Press “  ” to select “Printer Diag”, and press “ 3 ” key.
6) Press “  ” key to select “IOT Diag”, and then press “ 3 ” key.
7) Press “  ” key to select “Digital Output”, and then press “ 3 ” key.
8) Press “  ” or “  ” key to select test item.
9) Press “ 3 ” key to execute the test.
Parameters for the Digital Output Test are as follows.
Code Components
DO-0,1,2,3 Main Motor
DO-5,6,7,8 Sub Motor
DO-a,b,c,d Feed Drive
DO-f,10,11 Deve Motor
DO-13,14,16,17 Duplex Motor
DO-19,1a,1b,1c Teay 2 Feed Motor
DO-1e,1f Fan
DO-21 Yellow Toner Motor
DO-23 Magenta Toner Motor
DO-25 Cyan Toner Motor
DO-27 Black Toner Motor
DO-29 Regi Clutch
DO-2B MPF Turn Clutch
DO-2d MPF Feed Solenoid
DO-2f Tray 1 Feed Clutch
DO-31 Tray 2 Feed Clutch
DO-33 Tray 2 Turn Clutch
DO-35 Duplex Clutch