3 - 172
Chapter 3 Removal and Replacement Procedures (RRPs)
Version 2 2007.03.20
Replacement 44 MPF COVER (PL13.2.99)
1) Replace the MPF COVER to the FRONT COVER by mating the left and right side fitting holes
on the MPF COVER with the holes on the FRONT COVER.
2) Insert the SHAFT PIVOT MSI into the left and right side fitting holes on the MPF COVER,
and then secure the SHAFT PIVOT MSI with the hook.
When performing the step described below, make sure that the LEVER MSI 1 is on the
LINK ASSY MSI R.
3) Mate the LINK ASSY MSIs on the left and right sides of the MPF COVER with the fitting
holes on the FRONT COVER. Insert the PIN PIVOT MSI and secure with the hook.
4) Close the MPF COVER.
To Next Page
