How to Use This Guide
– 4 –
For information on how to install the switch, see the following guide:
Installation Guide
For all safety information and regulatory statements, see the following documents:
Quick Start Guide
Safety and Regulatory Information
Conventions The following conventions are used throughout this guide to show information:
Note:
Emphasizes important information or calls your attention to related features
or instructions.
Caution:
Alerts you to a potential hazard that could cause loss of data, or damage
the system or equipment.
Warning:
Alerts you to a potential hazard that could cause personal injury.
Revision History This section summarizes the changes in each revision of this guide.
December 2014 Revision
This is the fourth version of this guide. This guide is valid for software release
v1.2.2.0. It contains the following changes:
â—† Added information for ECS4620-28F-DC.
July 2014 Revision
This is the third version of this guide. This guide is valid for software release v1.2.2.0.
It contains the following changes:
â—† Added information for ECS4620-28T-DC.
â—† Added "Issuing MAC Address Traps" on page 205.
â—† Updated parameter information under "Configuring VLAN Settings for
ARP Inspection" on page 344.
â—† Updated parameter list under "DoS Protection" on page 365.
â—† Updated parameter information under "Configuring Ports for IPv4 Source
Guard" on page 368.
To Next Page
Loading...
Need help?
General