How to Use This Guide
– 5 –
â—† Updated command usage and parameter information under "Configuring
Static Bindings for IPv4 Source Guard" on page 370.
â—† Updated parameter information under "Configuring VLAN Settings for
ARP Inspection" on page 344.
â—† Added "UDLD Configuration" on page 533.
â—† Updated parameter information under "Setting IGMP Snooping Status
per Interface" on page 550.
â—† Updated parameter list under "Displaying IGMP Snooping Statistics" on
page 558.
May 2014 Revision
This is the second version of this guide. This guide is valid for software release
v1.2.1.3. It contains the following changes:
â—† Added information for ECS4620-28F, ECS4620-T, and ECS4620-P.
â—† Extended configurable VLAN range from 1-4093 to 1-4094.
â—† Added the section "Stacking" on page 110.
â—† Updated command usage and parameter section under "Configuring by
Port List" on page 118.
â—† Updated parameter section under "Displaying Connection Status" on page 121.
â—† Updated parameter section under "Configuring Transceiver Thresholds" on
page 134.
â—† Updated parameter section under "Configuring VLAN Groups" on page 166.
â—† Updated parameter section under "Configuring MAC-based VLANs" on
page 191.
â—† Added the section "Configuring MAC Address Learning" on page 197.
â—† Updated parameter section under "Setting Static Addresses" on page 199.
â—† Updated parameter section under "Rate Limiting" on page 231.
â—† Updated parameter section under "Configuring an Extended IPv6 ACL" on
page 331.
â—† Updated parameter section under "Configuring Global Settings for ARP
Inspection" on page 342.
To Next Page
Loading...
Need help?
General