How to Use This Guide
– 6 –
â—† Updated command usage section under "Configuring Port Security" on
page 351.
â—† Updated command usage section under "Setting the Port PoE Power Budget"
on page 418.
â—† Updated private traps in Table 29, "Supported Notification Messages," on
page 429.
â—† Updated command usage section under "Switch Clustering" on page 458.
â—† Updated parameter section under "Specifying Static Interfaces for a Multicast
Router" on page 546.
â—† Updated parameter section under "Configuring MVR6 Domain Settings" on
page 604.
â—† Updated parameter section under "Configuring IPv6 Interface Settings" on
page 626.
â—† Updated parameter section under "Configuring Static Routes" on page 681.
â—† Updated command usage section under "Clearing Entries from the Routing
Table" on page 702.
â—† Added BGP to the RIP parameter list under "Configuring Route Redistribution"
on page 707.
â—† Added BGP to the OSPF parameter list under "Redistributing External Routes"
on page 734.
December 2013 Revision
This is the first version of this guide. This guide is valid for software release v1.1.1.1.
To Next Page
Loading...
Need help?
General