Chapter 19
| Spanning Tree Commands
– 521 –
Default Setting
Floods to all other ports in the same VLAN.
Command Mode
Global Configuration
Command Usage
The spanning-tree system-bpdu-flooding command has no effect if BPDU
flooding is disabled on a port (see the spanning-tree port-bpdu-flooding
command).
Example
Console(config)#spanning-tree system-bpdu-flooding
Console(config)#
spanning-tree tc-prop This command configures a topology change propagation domain. Use the no
form to remove a propagation domain.
Syntax
spanning-tree tc-prop group group-id {ethernet interface |
port-channel trunk-id}
group-id - Group identifier. (Range: 1-255)
interface - unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number or list of ports. To enter a list, separate
nonconsecutive port identifiers with a comma and no spaces; use a
hyphen to designate a range of ports. (Range: 1-28/52)
trunk-id - Trunk index (Range: 1-16)
Default Setting
All ports and trunks belong to a common group.
Command Mode
Global Configuration
Command Usage
A port can only belong to one group. When an interface is added to a group, it is
removed from the default group. When a TCN BPDU or BPDU with the TC flag set is
received on an interface, that interface will only notify members in same group to
propagate this topology change.
To Next Page
Loading...
Need help?
General